Hi Team,
I am facing an issue with creating a Remaining Requirement in RBATP. Could you please help me regarding this?
The below is the scenario:
I have created 3 Products P1, P2, and P3 in 2 Locations L1 and L2. The stocks of P1,P2,and P3 are all 0 in both L1 and L2.
I have created Product Substitution Procedure PSP1, Location Determination Procedure LDP1,and Rule Control RC1. I have assigned these to the Rule R1. In the Rule Control RC1, I have used the Access Strategy 01(Start from top of list) for both Product and Location. In RC1, I have specified "Combine Qualified Location with All Products, then Qualified Product with all Locations".
In the Check Instructions, I have chosen "Create Remaining Requirement according to Last Substitution".
I have created a Sales order of 10 for P2 in L1. Based on my above Rule Settings, P1 in L1 will be checked.
Since P1 in L1 is also 0, P2 in L1 is being checked.
Since P2 in L1 is also 0, P3 in L1 is being checked.
Since P3 in L1 is also 0, P1 in L2 is being checked.
Since P1 in L2 is also 0, P2 in L2 is being checked.
Since P2 in L2 is also 0, P3 in L2 is being checked.
Since P3 in L2 also is 0, the sales order is unconfirmed and a Remaining Requirement of 10 is being created for P3 in L2.
With the above system setup and the same Access Strategy, is there a way that the Remaining Requirement can be created for P3 in L1? Could you please let me know if this is possible through Standard RBATP functionality? If this is not possible through Standard RBATP functionality, could you please let me know if this can be achieved through a User Exit or through any other process?
Thanks in advance for your help and for your time.
Thanks & Regards,
Srikanth.